98127 EN 2.2 - 12 2010 9 / 19 www.santos.fr
SANTOS : Instruction and maintenance manual
SAFETY / MAINTENANCE
SAFETY DEVICES
If the problem persists, switch off the power supply to the machine (unplug the cord
from the mains socket (8)) and call in the maintenance service or contact a
SANTOS approved dealer.
Bowl presence safety device:
1. The bowl (2) must be centered and held firmly in the upper position between the bowl
support (3) and the machine frame (4) before the appliance is allowed to work.
2. The bowl must be present to allow the appliance to be started.
3. When the bowl (2) is unlocked, this stops the appliance.
4. A cut in the mains power supply results in the On / Off switch (13) stopping (position 0).
5. Re-starting the beater-mixer requires specific operation of the On / Off switch (13)
again (position 1).
"Motor overload" safety feature:
Should the motor (15) become blocked (foreign body, object that is too hard) the On / Off
switch (13) automatically trips to the 0 position.
Correct the problem and press the On / Off switch (13) (position 1).
"Motor overheating" safety feature:
If the motor overheats, the On / Off switch (13) automatically trips to the 0 position. Wait
for the motor to cool (15 to 30 minutes), then push the On / Off switch (13) (position 1).
"Tool access" safety feature:
The beater-mixer can only start when the safety grid (9) is in the lowered position.
When the safety grid (9) is closed, there is no access to the tools in the bowl during
processing operations.
The safety grid does however allow products to be added during operation without having
to raise it.
!
To Next Page
Loading...
