98127 EN 2.2 - 12 2010 10 / 19 www.santos.fr
SANTOS : Instruction and maintenance manual
MAINTENANCE
Prior to carrying out any intervention on the appliance, it must be disconnected from the
mains without fail.
Discharging the capacitor:
Use a screwdriver with insulated handle to touch the 2 connectors on the
capacitor (19). The appearance of an electric arc shows that the capacitor
has discharged.
Spare parts:
IMPORTANT: Use of spare parts other than certified original SANTOS parts
is prohibited
This machine requires no specific maintenance. The bearings are lubricated for life.
If work is required to replace worn parts such as transmission belt, tools, or the electric or
other components, refer to the parts list (see exploded view at the end of the manual).
For all spare part orders (see references in the exploded view at the end of the manual),
state:
the type,
the machine serial number and
the electrical characteristics
marked under the machine.
Changing a worn belt on the variable speed drive (replacement after breaking)
Before proceeding with the variable speed drive belt (20) change it is recommended to
stop the beater-mixer at slow speed.
1. Disconnect the appliance from the mains.
2. Unscrew the locking screw (17) and remove the cover (18).
3. Discharge the starter capacitor (19).
4. Lift the belt (20) to disengage it from the driven pulley (21) (turn the pulley by hand
to make it easier to remove the belt).
5. Disengage the belt (20) from the drive pulley (22) and remove the belt from the
beater-mixer.
Fitting the new variable speed drive belt
1. Fit the new belt (20) on the drive pulley (22).
2. Lift the belt (20) to fit it on the driven pulley (21) (turn the pulley by hand to make it
easier to engage the belt).
!
!
To Next Page
Loading...
