98127 EN 2.2 - 12 2010 8 / 19 www.santos.fr
SANTOS : Instruction and maintenance manual
CHANGING THE TOOL
All tool changes must be carried out with the appliance halted and the bowl support in the
lowered position.
FITTNG:
1. Place the tool on the rotating shaft (16)
2. Push the tool upwards,
3. Turn and lift the tool slightly anticlockwise in order to engage the pin bayonet on the
tool rotation shaft (16).
REMOVING:
1. Do the same operations as for fitting, in reverse.
CLEANING:
IMPORTANT:
Stop the appliance and unplug its power cable from the
mains.
Cleaning with a jet of water or by pressure is not allowed.
It is recommended to clean the appliance as soon as you have finished using it.
It will be easier to clean if you do not allow the remaining scraps of food to dry.
Clean the tool (hook, paddle or whisk) after use with water or a detergent made for
dish washing. Then rinse and dry.
Clean the stainless steel bowl after use with water or a detergent made for dish
washing. Do not use abrasive products or pads to clean the bowl.
Clean those parts of the frame in contact with the food using water or a detergent
made for that purpose. Then rinse and dry.
The base (24) is to be cleaned with a soft damp sponge, then dried.
!
To Next Page
Loading...
