98127 EN 2.2 - 12 2010 12 / 19 www.santos.fr
SANTOS : Instruction and maintenance manual
FAULT FINDING
Identifying the cause of appliance stoppage with precision.
If the problem persists, switch off the power supply to the appliance (unplug
the cable from the mains socket) and call in the maintenance service or
contact a SANTOS approved dealer.
The appliance will not start:
Check : that the grid is in the low position, and that the bowl is locked in the up
position
Check : the mains supply, the condition of the supply cord and plug,
Check that the On/Off lamp (13) lights up when the switch is at position "1-On".
Call in a specialist technician to check the appliance's electrical components.
The appliance stops after the motor has overheated:
(the metal casing around the speed change lever is hot)
Press the "mushroom-head switch" (14), disconnect the appliance from the mains
socket and follow the instructions in the "motor overheating safety feature" section
The appliance stops following an overload:
If the motor stalls during operation, see the "motor overload safety feature" section
The tool no longer rotates and the lamp on the switch (13) is lit:
press the "mushroom-head" switch (14), disconnect the appliance from the mains
socket and check the condition of the belt (20), see the "Maintenance / belt change"
section.
!
To Next Page
Loading...
