Ω • • •
mV•V•Ω
• • •
•Hz
•
COM
—
2
—
1-3 Overload protections
*10A continuous
15. Never use meter for measuring the line connected with
equipment (i.e. motors) that generates induced or surge
voltage since it may exceed the maximum allowable voltage.
16. Never use uncased meter.
17. Be sure to use a fuse of the specified rating or type. Never use
a substitute of the fuse or never make a short circuit of the fuse.
18. When connecting and disconnecting the test leads, first
connecting the ground lead (black one). When disconnecting
them, the ground lead must be disconnected last.
19. Always keep your fingers behind the finger guards on the
probe when making measurements.
10. Be sure to disconnect the test pins from the circuit when
changing the function.
11. Before starting measurement, make sure that the function and
range are properly set in accordance with the measurement.
12. Never use meter with wet hands or in a damp environment.
13. Never open tester case except when replacing batteries or
fuse. Do not attempt any alteration of original specifications.
14. To ensure safety and maintain accuracy, calibrate and check
the tester at least once a year.
15. The multimeter restricts in use in indoor.
DC•AC 500mA
Peak max : 300V
Hz
µA•mA
0.63A/250V Fuse
IR 1.5kA
DC
•
AC 10A*A
mV
V
Functions
Input
terminals
Maximum rating
input value
Maximum overload
protection input
DC•AC 500mV
DC•AC 1000V
600VDC/VAC rms
1050V rms, 1450Vpeak
600VDC/VAC rms
Voltage and
Current input
prohibited
600VDC/VAC rms
µA•mA
•
COM
A
•
COM
12.5A/500V Fuse
IR 20kA
To Next Page
Loading...
