Safety, Operation and Maintenance Manual-September 30, 2019
2-5
2.Safety
2.1 Foreword
This Safety, Operation & Maintenance Manual is a guide for you to operate your machine properly.
It contains technical and safety information necessary for operation of your machine. Read and
understand each section of the manual.
Machines covered by this manual are used for various operations under normal conditions. Never
use the machine in flammable or explosive environment, or in areas containing asbestos dust.
Standard SANY rotary drilling rig application range: below 2000 meters above the sea level.
-20°C-40°C ambient temperature.
Only eligible, experienced operators with an official license (according to local laws) are allowed to
operate the machine. Always operate your machine according to national, provincial, prefectural
and municipal laws and regulations.
Before starting operation and maintenance, operator shall observe the following items:
• Read and understand the whole manual.
• Read and understand the safety notices contained in this manual and the safety messages on
the machine.
• Never apply or operate your machine under any circumstances in a manner that is prohibited in
this manual.
• If the amount of fuel added, content of particulates or latitude is beyond the specification of this
type of machine, damage could occur and the warranty of your machine would become invalid.
SANY cannot anticipate every possible circumstance that might involve a potential hazard during
operation and maintenance. The safety messages in this manual and on the product are, there-
fore, not all inclusive. If a procedure, work method or operating technique that is not specifically
recommended in this manual is used, you must be sure that it is safe for you and for others. You
should also ensure that the product will not be damaged or be made unsafe by the operation, lubri-
cation, maintenance or repair procedures that you choose.
The information, specifications, and illustrations in this publication are on the basis of information
that was available at the time that the publication was written. SANY reserves the right to change
these information at any time without prior notice. Consult SANY dealer to obtain the latest infor-
mation or if you have any question on the information provided in this manual.
2.2 Hazard Words
2.2.1 Hazard word levels
The following hazard words are used to inform you there may be potential dangers that lead to per-
sonal injury or damage.
SR400R Rotary Drilling Rig
Safety
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
mengkf 2022-04-21
To Next Page
