SANY SR400R - Travel Reducer Oil

To Next Page

To Previous Page

Safety, Operation and Maintenance Manual-September 30, 2019

5-67

Fig.5-65 Dipstick

5.Remove dipstick. Add oil. For type and vol-

ume, see “” on page .

Fig.5-66 FULL Mark and ADD Mark

6. Make sure that the oil level between the

FULL mark and the ADD mark.

7. Check if metal chips or particles are in the

waste oil. Consult SANY after sales service

department if any metal chips or metal par-

ticles are found.

5.4.6.3 Travel reducer oil - change

CAUTION

Risk of injury!

Escaping pressurized fluids can cause injury to body parts.

Before assembling or dismantling media-conducting components such as hydraulic

hoses or plugs, make sure that they are pressure-free.

NOTICE

Risk of environmental pollution!

Improper handling of used oil can cause environmental pollution.

• Never spill any oil on the ground.

• Put your used oil in a clean plastic container with a tight lid. Never store used oil in a

container that once held chemicals, food, or beverages.

• Do not mix the oil with anything else, such as antifreeze, solvent, or paint.

• Take used oil to a service station or other location that collects used oil for recycling.

For more information, go to http://www. epa.gov/osw/conserve/materials/usedoil/

Before changing oil:

SR400R Rotary Drilling Rig

Maintenance

mengkf 2022-04-21

SANY SR400R - Travel Reducer Oil - Change