Sanyo Big PACi 18 Series - Test Run Procedure

2
2-22
2-24. Test Run Procedure
YES
YES
YES
NO
NO
NO
Fig. 2-22
Recheck the items to check
before the test run.
(See 2-11)
Check the combination (wiring) of
indoor and outdoor units.
(See 2-26-1)
Is system “single-type”?
(1 indoor unit is connected
to 1 outdoor unit)
Are multiple outdoor units
used?
(See 2-26-2) How to Set the Outdoor
Unit System Address
Set the outdoor unit system
address.
(See 2-26-1, -2) How to Set Automatic
Address
Set the automatic address
setting from outside unit.
Indicate (mark) the
combination number.
Turn the power back ON to
the indoor unit.
(See 2-26-3, -4)
Set the indoor unit control
unit to “TEST”.
(See 2-26-3)
Can
operation be
started?
(See 2-13)
Turn ON
the indoor
and outdoor
power.
(Automatic
Address)
(Automatic
Address)
(See 2-25)
Turn ON
the indoor
and outdoor
power.
Refer to “Table of
Self-Diagnostic
Functions” to check
the system.
In addition, refer to
2-26 and correct any
items that need to be
corrected.
Note: Check the indoor-
side drainage.
SM830161Book.indb22SM830161Book.indb22 2008/06/039:09:042008/06/039:09:04