Sanyo Big PACi 18 Series - Accessories; Installing the Receiver Unit

8
■
RCS-BH80BG.WL for XM, U and US Types
8-15. Accessories
No. Accessories Quantity
1
Receiver
(Enclosed 200 mm wiring)
1
2
Remote Controller
1
3
Remote Controller's Holder
1
4
AAA alkaline batteries 2
No. Accessories Quantity
4 Users Manual 1
5 Truss Self-Tapping Screws
4 X 16
2
6
Machine screws
2
7
Wood screws
2
8
Cable tie
1
8-16. Installing the Receiver Unit
●
When using a separately installed receiver as a built-in model, install it to the JIS switch box (field supply) shown
in the diagram on the right, which has been built into the wall on site in advance.
(1) Remove the face plate of the receiver by slipping a flat head
screwdriver or the like into the cutout on the
bottom.
(2) Install the receiver with the 2 enclosed machine screws (M4).
(3) Connect the receiver’s wiring (2 cores) with the wiring from
the indoor unit. (Refer to “8-17. Wiring the Receiver Unit”.)
When wiring receivers, be sure to double-check the terminal
numbers of the indoor unit before connecting them so there
are no mistakes in the wiring. (Damage will occur if high volt-
age [e.g. supply voltage] is applied.)
(4) Attach the face plate.
M4 X 25
Machine screws (2)
Receiver Unit
Spacers
Single outlet switch box
(no cover)
Face Plate
Cutout
Fig. 8-15
●
When using a separately installed receiver as an exposed model, attach it to a wall where the receiver can be
affixed.
(1) Put a flat head screwdriver or the like into the groove on the bottom of the receiver unit and twist it to remove the
bottom of the case. (Fig. 8-16)
(2) To enable the receiver’s wiring to stick out from the upper part of the case (thin part at center-top), use side-
cutters or the like to cut a hole in the case big enough for the remote control cord (sold separately). (Fig. 8-17)
(3) Disconnect the wires that were connected at shipment from the connector.
(4) After installing the remote control cord (sold separately) at the position in Fig. 8-18 with the enclosed cable
tie,connect it to the connector on the receiver.
(5) Shape the remote control cord at the top of the PCB so it fits inside the receiver and after configuring the wiring
like it is in Fig. 8-19, attach the lower case. When doing this, arrange the head of the cable tie so it faces side-
ways.
(6) Remove the face plate and use the woodscrews (2) to install the receiver unit.
(7) Use the cord clip that comes enclosed with the remote control cord to fasten it to the wall.
(8) Attach the face plate.
Outlet in the upper part of the
case for the remote control cord
Cable tie (Enclosed)
Connector
Remote Control Cord
(Sold Separately)
A
bout 2 to 3 mm
Remote Control Cord
(Sold Separately)
Cable tie
(Enclosed)
Wood screws
(2)
Receiver Unit
Fig. 8-18
Fig. 8-19
Fig. 8-16 Fig. 8-17
8-9
SM830161Book.indb9SM830161Book.indb9 2008/05/279:11:352008/05/279:11:35