Sanyo Big PACi 18 Series - 5-7. How to Remove the Electrical Component Box

5-16
5
5-7. How to Remove the Electrical Component Box
1. Remove the front panel and inspection panel from the outdoor unit.
2. Remove all local wires connected to the electrical component box.
3. Remove the wires (temperature sensor, coils of every sort of valve, pressure switch, fan motor and wires for
connecting compressor) connected to the electrical component box in the unit.
4. Remove the fixture screws (x6) as shown in the diagram and remove the electrical component box.
NOTE:
Be sure to remove the upper left side screw marked by * in the diagram because that screw cannot be seen
from the front side.
Outdoor unit before removal of front panel Fixture screws (x6) for electrical component box
Electrical component box after removal
Inspection panel
Front panel
Removing
SM830161Book.indb16SM830161Book.indb16 2008/06/039:10:282008/06/039:10:28