Sanyo CP21MF2 - Tuning of the Channels - Automatic; Automatic Channel Tuning; Colour System Selection; Sound System Selection

Normally, set the colour system to “AUTO”,
if the clear picture cannot be obtained,
change the colour system until the optimum
image can be produced.
P▲
P▼
5
Press the VOLUME (+) button to start
channel tuning.
1
4
Select “SEARCH” by pressing the
Programme UP or DOWN button.
SEARCH
POSITION
SYSTEM
MODE
SIF
AUTO
START
1
AUTO
BG
To select colour system
1) Select SYSTEM with the PROGRAMME
UP or DOWN button.
2) Press the VOLUME ( + or - ) button to
select a optimum colour system.
SEARCH
POSITION
SYSTEM
MODE
SIF
AUTO
START
1
AUTO
BG
B/G
(5.5MHz)
D/K
(6.5MHz)
I
(6.0MHz)
M
(4.5MHz)
When the sound is not clear or no sound is
produced on a programme number position,
change the sound system.
To select sound system
1) Select SIF with the Progamme UP or
DOWN button.
2) Press the VOLUME ( + or - ) button to
select an optimum sound system.
SEARCH
POSITION
SYSTEM
MODE
SIF
AUTO
START
1
AUTO
BG
AUTO
PAL
NTSC4.43
NTSC
(Refer to Broadcast Transmission System List
indicated by page 10 in a setup of sound system.)
(Refer to Broadcast Transmission System List
indicated by page 10 in a setup of colour system.)
PICTURE
AUDIO
PRESET
LANGUAGE
GAME
Up to 256 broadcast stations in your
reception area can be stored in the
electronic memory.
There are three ways of tuning as follows;
1. Automatic Tuning (the basic way):
All receivable channels are automatically tuned
in and memorized in consecutive programme
position.
2. Semi-Auto Tuning:
Use to preset a receivable channel in any
desired programme position, e.g. the position
with the same number as the channel.
3. Manual Tuning:
Manually tune a channel if it cannot be auto-
matically tuned, such as when the signal is
poor.
1
Press the MENU button for MAIN menu
display.
SEARCH
POSITION
SYSTEM
MODE
SIF
AUTO
START
1
AUTO
BG
2
Select “PRESET” by pressing the
Programme UP or DOWN button.
3
Press the VOLUME + or - button for
PRESET menu display. On entering
PRESET display, Automatic Tuning will
be selected initially.
Automatic Tuning
Tuning of the Channels
SELECT ENTER
M
EXIT
PICTURE
AUDIO
PRESET
LANGUAGE
GAME
After all receivable channels have been found
and stored, the TV set automatically returns
to programme position “1”.
■ The Automatic Tuning operation can be
cancelled at any time by pressing the
Programme UP or DOWN button.
13
INST. M_21-C5ZY-A(AUS) 9/15/03 12:49 PM Page 13