Sanyo CP21MF2 - Remote Control Operation; Remote Battery Installation

Remote Control Transmitter
6
1. Open the battery cover.
2. Install two “AA” 1.5 volt batteries so that the “+” and “-”
marks on the batteries match the “+” and “ - ” marks
inside the unit.
3. Close the battery cover.
Note: Replace the batteries when the TV set is showing
the following symptoms:
Operation is unsteady or erratic, sometimes the TV set
does not work with transmitter.
Discharged batteries may leak and damage the unit. The
normal life of batteries should be from nine to ten months.
Battery Cover
Battery installation of the Remote Control Transmitter
0
7
14
85
23
6
9
P▲
P▼
JXMYA
-/--
PP
TV/AV
A B
CH SCAN
TIMER
MENU
PIC MODE
SWAP
BASS SURROUND
SOUND MUTE
TV/AV Selector
Digit
RECALL /
COLOUR SYSTEM
VOLUME
+
PROGRAMME DOWN
ALTERNATE
CHANNEL SCAN
TIMER
POWER ON/OFF
Programme
Selector
PROGRAMME UP
VOLUME -
MENU
PICTURE MODE
SWAP
BASS
STEREO/MONO
SURROUND
The selected mode will switch
alternately between TV mode
and AV mode each time the
TV/AV Selector is pressed.
Note : When RC button is pressed, the power indicator will blink in yellow light.
BASS EXPANDER
INST. M_21-C5ZY-A(AUS) 9/15/03 12:49 PM Page 6