Sanyo CP21MF2 - Connecting Other Equipment - AV Usage; Programme Selection During VCR Playback; Selecting Colour System in AV Mode; Connecting to Monitor Output Jacks

21
■ To dub video from the AV terminal input, select AV
position by pressing the TV/AV Selector.
The picture signal being displayed on the TV screen is output through the Monitor Output
Jacks. Use these terminals to record TV broadcasts and for video dubbing from AV input ter-
minals.
■ To record TV programme, select TV mode
by pressing the TV/AV Selector and
record the desired programme.
Colour system setting for AV position is automatically stored in the memory.
Each time the RECALL/COLOUR SYSTEM button is pressed, colour system is changed
as follow;
Depending on the type of video tape or connected AV equipment being used, it may be nec-
essary to select colour system. In this case, press the RECALL/COLOUR SYSTEM button
and select a suitable colour system.
TV mode
AV
15
Selecting the Colour System in AV mode
Connecting to the Monitor Output Jacks
Note: The audio left channel and right channel which were inputted from AV
Input Jacks are mixed, and are outputted from Audio Monitor Output Jack.
■ You can select a TV programme while watching a playback from a VCR
For example:
● To select programme position “9” while watching a playback from external VCR, press “9”
button of the remote control. The TV set returns to the TV mode and programme “9” will
be selected.
● To select the programme position “26”, press Digit (--/-) button, “2” then “6” button. Then
TV set returns to the TV mode and programme position “26” will be selected.
Note: Pressing either of the PROGRAMME UP or DOWN buttons of the remote
control or the TV will return the TV to the TV mode.
Connecting other Equipment
AV
AUTO
AV
PAL
AV
NTSC4.43
AV
NTSC
Recording TV broadcasts or tape dubbing
VCR for recording
INPUT
OUTPUT
A
U
D
I
O
V
I
D
E
O
+ +
R
L
ANT.75
Ω
MONO
To video and audio inputs
INST. M_21-C5ZY-A(AUS) 9/15/03 12:49 PM Page 21