7
General Operation
To switch on or off the TV ;
Press the Mains ON/OFF button.
The power of the TV is turned on or off com-
pletely. If no picture appears but the
Standby and Power indicator illuminates,
press the Power ON/OFF button of the
remote control transmitter as the TV set is in
standby mode.
To set the TV to standby mode;
Press the Power ON/OFF button.
During Standby mode the Standby and
Power indicator illuminates more brightly.
To turn on the TV from the standby
mode, press any of the following button.
● Power ON/OFF button of the remote
control transmitter.
● Programme UP/DOWN of the remote
control transmitter or the TV set.
● 1 to 9, 0 button on the remote control
transmitter.
Important !
Be sure to set the Mains ON/OFF switch to
the off position, if the power failure occurs
while viewing.
This TV set incorporates the AUTO SHUT
OFF function. Even if the TV is left on after
you have gone to sleep, the TV set changes
to the standby mode within 10 minutes after
all broadcasts have ended.
OFF 0:10
Press the Programme UP (P▲ ) button to
select the next programme position.
Press the Programme DOWN (P▼ ) button
to select the previous programme position.
Channel Scanning
Press the CHANNEL SCAN button to
search for a programme. The channel posi-
tions are automatically scanned, and the
channel scanning will stop at the position
where it began. To stop at the position you
want, press this button again.
Power ON/OFF
Auto Shut Off Function
Direct Programme Selection
Programme Up and Down
CH SCAN
2
5
-/--
To select programme position 8;
8
- -
27
2 -
Press “8” button.
- -
Example
8
Press the Digit button twice. Press “2”button. Press “5”button.
To select programme position 125;
To select programme position 255;
Press the Digit button 3 times. Press “5” button.
Press “5”button.
-/--
12 -
125
1--
27
To select programme position 27;
-/--
5
5
-/--
-/--
25 -
255
2--
-/--
Press the Digit button. Press “2”button. Press “7” button.
To Next Page
Loading...
