ELECTRONIC CONTROL RESET
Press the SEL button 0 for about 3 seconds until the unit beeps, the audio controls, except for vol-
ume, will be reset
BASSXPANDER (BASX) - l/2 . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
BASSXPANDER is a dual-mode sound equalization feature Press button @ to select the BASSXPANDER
modes as follows;
,-- b-l - b-2 - OFF 1
BASSXPANDERofferstwopresetmodes: b-l enhancesthelowand highfrequencieswhile b-2enhancesthe
low frequencies and reduces the high frequencies
RADIO SELECTION BUTTON (BND) . . . . . . . . . . , . . . . . . . . . . . 5
Press the BND button 0 to switch from tape, CD player or CD changer* mode to radio
* If a CD changer is connected
Each time the button is pressed, the function changes as shown below
FM1 - FM11 - AM
TAPE SELECTION BUlTON . . . . . . . ..“.....“.“...“.......
6
Press the TAPE button @with a tape inserted in the tape slot to switch from radio, CD player or CD changer*
mode to tape mode
* If a CD changer is connected
CD PLAYER OR CD CHANGER* SELECTION BUTTON
(CD/CD-CH) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...*....
7
Press the CD/CD-CH button 0 with a CD inserted in the disc slot to switch from radio or tape mode to CD player
or CD changer mode
* If a CD changer is connected
Pressing the button will change the mode as follows:
q
When a CD is loaded in the CD player and a CD changer is not connected;
Radionape - CD player - CD player pause 1
q
When a CD is not loaded in the CD player and a CD changer is connected,
Radionape - CD changer - CD changer pause
q
When a CD is loaded in the CD player and a CD changer is connected,
Radio/Tape - CD player - CD changer 1
CLOCK BUlTON (DISP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8
Press the DISP button @ to switch between the clock and audio display When an audio function is performed
while the time display is selected, the audio display will appear for 5 seconds, then the display will return to the
time mode
TO CANCEL THE BEEP TONES . . . . . . . . . . . . . . . . . . . . . . . . .
6
0 To cancel all beep tones, press TAPE button @for more than 3 seconds with no tape in the slot, and then
bEE ~/zFFisdisplayed
9.
q
To turn on the beep tones again, perform the same procedure The beep tones are set and j-, E E p /o ,-, is
disolaved
To Next Page
Loading...
