GB-25
Selecting the action Windows is to take
After connection, the following screen will appear
(Windows XP only).
- For Windows98/98SE/ME/2000, this operation is not
needed.
The screen shots are of Windows XP.
Adjust your settings to match your PC’s environment.
In this manual, [Take no action] is selected, [Always do
the selected action] is checked, and [OK] is clicked. This
completes the connection to the PC.
When connected to the PC, the unit display will be as
shown below and none of the operating buttons will
work.
Before disconnecting the unit from the PC, be sure to
follow the steps on the next page. Do not disconnect
during data transfer.
Connected to PC Transmitting to/from PC
2) Check
1) Select
3) Click
To Next Page
Loading...
