Sanyo PDP-42WV1 - Page 10

-10-
■ To adjust
The next 5 pages show Data for adjustment.
To select adjustment item, press
e
or
d
button on the remote control unit.
To adjust data, press
7
or
8
button on the remote control unit.
The all data adjusted in service mode memorizes into non-volatile memory IC.
Note: In the explanation all buttons are indicated for remote control unit without any notice.
Service Mode Display
Sub-Image
1) Select adjustment item by
e
but-
ton.
Adjustment item is displayed in order. To
reverse adjustment item, press
d
button.
Selected by
e
or
d
Button Adjusted by
7
or
8
Button.
3) To exit the Service Mode.
To exit the service mode, press POWER ON-
OFF button on the monitor or remote control
unit.
2) Adjust the data by
7
or
8
button.
Sub-Cont PC 1ah(26)
Adjustment Item Adjustment Data
Number
Adjustment
Sub-Image
Sub-Cont
0
PC
Main
42WV1
1ah(26)
215
Model 215(WV1)
Sub 138
Temp1
27
Temp2 23
PDP Time 10h
0
Adjustment Mode
Adjustment Name
✽ This menu is for factory data,
not used for servicing.
✽