53
Power management
Time left before the lamp is off.
Press the SELECT button at
Power management and this
dialog box appears. Use the
Point
7 8 buttons to choose
one of the three options.
Press the Point
d button to
select the timer, and then use
the Point
7 8 buttons to set
timer.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not used for a certain
period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with “No signal”
appears. It starts the countdown until the lamp is turned off.
The countdown time can be set between 1–30 minutes.
Use the Point 7 8 buttons to set the countdown timer.
Select one of the following options:
Ready ................. When the lamp has been fully cooled
down, the POWER indicator changes
to fast blinking. In this condition, the
projection lamp can be turned on if the
input signal is reconnected or any button
on the top control or remote control is
pressed.
Shut down ......... When the lamp has been fully cooled
down, the power will be turned off.
Off ..................... Power management function is off.
On start
When this function is set to “On,” the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
✔Note:
•Besuretoturnofftheprojectorproperly(see
“TurningOfftheProjector”onpage25).Ifthe
projectoristurnedoffintheincorrectsequence,the
Onstartfunctiondoesnotworkproperly.
✔Note:
•Factorydefaultis“Ready:5min.”
Setting
To Next Page
Loading...
Need help?
General
