Need help?Do you have a question about the Sanyo PLC-XC56 and is the answer not in the manual?
General| Brightness | 2500 ANSI Lumens |
|---|---|
| Contrast Ratio | 500:1 |
| Display Technology | LCD |
| Aspect Ratio | 4:3 |
| Output Ports | VGA |
| Resolution | 1024 x 768 pixels (XGA) |
| Projection Size | 30 - 300 inches |
| Throw Distance | 1.2 to 12.2 meters |
| Lamp Type | UHP |
| Input Ports | S-Video |
| Power Consumption | 280 W |
| Noise Level | 35 dB |
| Lamp Life | 2000 hours (Normal mode), 3000 hours (Eco mode) |
Instructions on electrical shock, fire hazards, usage, and servicing.
Ensures proper operation by maintaining adequate ventilation and placement.
Detailed description of all rear terminals and their functions.
Overview of the top control panel buttons and indicators.
Description of all buttons on the remote control.
Guidance on projector positioning for optimal image projection.
Detailed instructions and diagrams for connecting a computer to the projector.
Procedure for connecting the projector to the AC power outlet.
Step-by-step guide on how to turn on the projector.
Instructions for properly turning off the projector and cooling down the lamp.
Selecting Computer 1 or Computer 2 as the input source.
Selecting Video or S-video input sources.
Shows projector temperature status and actions for overheating.
Information on filter function, clogging, and replacement procedures.
Detailed steps for removing and installing the filter cartridge.
Step-by-step guide for replacing the projection lamp.
Lists common problems and their solutions for projector operation.
Explanation of indicator lights and projector status conditions.
Details mechanical, signal, optical, interface, audio, power, and environment specs.
Connects the projector to the LAN and configures network settings.
Enters the projector's IP address into the web browser's address bar.
Logs into the projector's setting page using user name and password.
Performs basic initial settings like language, model name, and PIN code.
Sets IP address, subnet mask, gateway, DNS, and projector name.
Controls projector power (ON/Standby) and checks status via web interface.
Adjusts PC signal parameters like sync, dots, and position via web interface.
Troubleshooting steps when the projector setting page does not appear in the browser.
Step-by-step guide for installing the PJ Network Manager software.
Logs into the projector via web browser to control and set it up.
To Next Page
