Sanyo PLC-XC56 - Computer Input; Input Source Selection (RGB: Computer 1;Computer 2(Analog))

27
Choose either Computer 1(RGB) or Computer 1(Scart) or Computer 2(Analog) by pressing the INPUT button
on the top control or press the COMPUTER 1 button or Computer 2 on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Computer Input
COMPUTER 1 button
3Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
Computer
1
Top Control
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point
Ÿź buttons to select Input and
then press the Point
Źor the SELECT button.
Use the Point
Ÿź buttons to select Computer 1.
When Computer 1 is selected, press the Point Ź
button to access the submenu items. Use the Point Ÿ
ź
buttons to select the RGB input source and then
press the SELECT button.
Computer 1(RGB)
Computer 1(Scart)
RGB(PC digital)
NTSC
RGB(PC digital)
INPUT button
Video
Computer 2 (PC digital) /
(AV HDCP) /
(Analog)
S-video
Computer 1 ( RGB)
/(Component) / (Scart)
Computer 2 (PC digital)
Computer 2 (AV HDCP)
Computer 2 (Analog)
COMPUTER 2 button
Input Source Selection (RGB: Computer 1/Computer 2(Analog))
Direct Operation
Menu Operation