Sanyo PLC-XC56 - Resetting the Lamp Counter; Lamp Handling Precautions

65
Maintenance and Cleaning
This projector uses a high-pressure lamp which must be handled carefully and properly.
Improper handling may result in accidents, injury, or create a fire hazard.
Ɣ /DPS OLIH PD\ GLIIHU IURP ODPS WR ODPS DQG DFFRUGLQJ WR WKH HQYLURQPHQW RI XVH 7KHUH LV QR JXDUDQWHH Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee
of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time
than other similar lamps.
Ɣ ,I WKH SURMHFWRU LQGLFDWHV WKDW WKH ODPS VKRXOG EH UHSODFHG LH LI WKH /$03 5(3/$&( LQGLFDWRU OLJKWV If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights
up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
(Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of
the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.
Ɣ $ /DPS PD\ H[SORGH DV D UHVXOW RI YLEUDWLRQ VKRFN RU GHJUDGDWLRQ DV D UHVXOW RI KRXUV RI XVH DV LWV A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its
lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in
which the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an
authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check
carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out
from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one
should check the inside of the projector except those who are authorized trained technicians and who
are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those
who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken
glass.
LAMP HANDLING PRECAUTIONS
Lamp counter
Be sure to reset the Lamp replacement counter after the
lamp is replaced. When the Lamp replacement counter is
reset, the LAMP REPLACE indicator stops lighting.
Press the MENU button to display the On-Screen
Menu. Use the Point
Ÿź buttons to select the Setting
and then press the Point
Ź or SELECT buttons.
Use the Point Ÿź buttons select Lamp counter and
then press the Point
Ź or SELECT button. Use the
Point
Ÿźbuttons to select Lamp counter reset and
then press SELECT button. The Lamp replacement
counter Reset?
appears. Select Yes to continue.
1
2
Another confirmation dialog box appears, select Yes to
reset the Lamp counter.
3
The Lamp
replacement
counter Reset
?
appears.
Select Yes, then
another confirmation
box appears.
Select Yes again
to reset the Lamp
counter.
Resetting the Lamp Counter