Sanyo PLC-XC56 - Input Source Selection (Component, RGB Scart 21-Pin)

38
Video Input
Choose Computer 1(Component) or Computer 1(Scart) by pressing the INPUT button on the top control or
press the COMPONENT button or the COMPUTER 1 on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
Use the Point Ÿź buttons to select Computer 1 and
then press the Point
Ź button.
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
Component
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
RGB (Scart)
Press the MENU button to display the On-Screen
Menu. Use the Point
Ÿź buttons to select Input and
then press the Point
Ź or the SELECT button.
3Note:
When the Input Search function is set to On1 or On2,
the input signal will be searched automatically (p.45).
COMPUTER 1 button
Top ControlRemote Control
3
Use the Point Ÿź buttons to select Component or
RGB(Scart) and then press the SELECT button.
RGB(PC digital)
RGB(PC digital)
Computer 1(RGB)
Computer 1(Scart)
COMPONENT button
Component
Video
Computer 2 (PC digital) /
(AV HDCP) /
(Analog)
S-video
Computer 1 ( RGB)
/(Component) / (Scart)
INPUT button
Direct Operation
Menu Operation
Input Source Selection (Component, RGB Scart 21-pin)