Sanyo PLC-WM5500L - Video Input; Video System Selection

45
If the projector cannot reproduce proper video image, select a
specific broadcast signal format from among PAL, SECAM, NTSC,
NTSC 4.43, PAL-M, and PAL-N.
The projector automatically detects an incoming video signal, and
adjusts itself to optimize its performance.
When the Video System is 1035i, 1080i or 1080p, select the
system manually.
If the projector cannot reproduce proper video image, select a
specific component video signal format from among 480i, 575i,
480p, 575p, 720p, 1035i, 1080i, and 1080p.
Video Jack or S-video Jack
The projector automatically detects an incoming video system, and
adjusts itself to optimize its performance.
When Video System is PAL-M or PAL-N, select the system
manually.
Video Input
1
AV System Menu (Video or S-video)
AV System Menu (Y, Pb/Cb, Pr/Cr)
2
Press the MENU button to display the On-Screen Menu. Use
the Point ▲▼ buttons to select Input and then press the Point
► or the SELECT button.
Use the Point ▲▼ buttons to select System and then press the
Point ► or the SELECT button.
3
Use the Point ▲▼ buttons to select the desired system and
then press the SELECT button.
Note:
The AV System Menu cannot be selected when selecting
RGB (Scart).
Video System Selection
Auto
Y, Pb/Cb, Pr/Cr Jacks
PAL/SECAM/NTSC/NTSC4.43/PAL-M/PAL-N
Auto
Y, Pb/Cb, Pr/Cr SIGNAL FORMAT