Sanyo PLC-XE50 - Page 45

Display
Blue back
Press the Point 7 8 buttons to switch on/off. When this
function is “On,” a blue image is displayed while the input
signal is not detected.
Press the Point 7 8 buttons to switch on/off. This function
decides to display the On-Screen Displays.
On ………………… Display all the On-Screen Displays.
Use this function when you want
to project images after the lamp
becomes bright enough. This mode is
set as a default.
Countdown off… Display the input image instead of
the countdown when turning on the
projector. Use this function when you
want to project the image as early as
possible even when the lamp is not
bright enough.
Off………………… Do not show the On-Screen Displays.
except:
●On-Screen Menu
● “Power off?”
●P-Timer
● “No signal” for Power management item (p.49)
●”Please wait...”
●Arrows for panning mode (p.35)
Setting
45