Sanyo PLC-XF46N - Page 18

- 18 -
Cabinet top unit
2-1
Cabinet-top unit removal.
1. Remove 8 screws and remove the Cabinet top unit.
(See Fig.2-1)
Fig.2-1
Fig.2-1a
Back View
Mechanical Disassemblies
Grill SP-R
Grill SP-L
Net
Net
A
B
B
C
C
DEC Inlay R/C-F
DEC Inlay A
R/C 1 Board
Cabinet front
1-7
Decoration Inlays and R/C-1 Board removal.
1. Remove screw-A and remove the R/C-1 Board.
2. Remove 2 screws-B and remove the DEC Inlay R/C-F.
3. Remove 2 screws-C and remove the DEC Inlay-A.
(See Fig.1-7)
1-8
Speaker Grills and Nets removal.
1. The bent portion is stretched and remove the Grille SP-L,
remove the Grille SP-R from cabinet front.
2. Remove the Nets.
(See Fig.1-8)
Mark the Grills as they are removed from the Cabinet front so that
they may be reassembled in the same location from which they
were removed. Be careful of the attached direction of Grills.
Fig.1-7
Fig.1-8