Sanyo PLC-XF46N - Page 27

- 27 -
The direction
of a wind.
(FN907)
Holder-C
Holder-C
Holder
Holder -C
Spacer
Spacer
Spacer
Spacer
Ballast 1
Ballast 2
Ballast 3
Ballast 4
B
B
Holder -E
FN907
The direction
of a wind.
(FN908)
A
A
Holder-D
FN908
The Ballast Board is being fixed with
Holder by hook. (4places)
FAN GUARD
FAN GUARD
Note;
Mark the Fans as they are removed from the holder so that they may be reassembled in the same
location from which they were removed. Be careful of the attachment direction of Fans.
See arrow mark in a figure.
Ballast units may be reassembled in the same location and direction from which they were removed.
Be careful of the attached direction of Ballast units.
Lamp Ballast Units 1-2
1. Remove 2 screws-A, remove the Fan(FN908) and FAN Guard.
2. Remove Lamp Ballast unit 1 and remove the Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
3. Remove Lamp Ballast unit 2 and Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
(See Fig.5-5a)
Lamp Ballast Units 3-4
4. Remove 2 screws-B, remove the Fan(FN907) and FAN Guard.
5. Remove Lamp Ballast unit 3 and Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
6. Remove Lamp Ballast unit 4 and remove the Spacer.
(Unhook the Fixer Clamp and remove the Lamp Ballast unit .)
(See Fig.5-5b)
5-5
Lamp Ballast Units disassemblies.
Fig.5-5aFig.5-5b
Mechanical Disassemblies