Sanyo PLC-XF46N - Page 93

–21R11_Y_DELAY_YC_MONO_50 Y Delay at Y/C Sep. signal 0 ~ 3 0
–22R04_C_TRAP_ADJ_SECAM Chroma trap f
0 Adj. (0: High, 1: Low) 0 ~ 15 13
–23R04_C_TRAP_ADJ_NTSC443 Chroma trap f
0 Adj. (0: High, 1: Low) 0 ~ 15 10
–24R0_HUE_NTSC Tint Control (for 60Hz) 0 ~ 63 35
–25R1_COLOR Color Control 0 ~ 63 20
–26R2_SHARPNESS Sharpness Control 0 ~ 63 5
–27R3_SUB COLOR_NTSC Sub Color Control 0 ~ 15 3
–28R3_SUB COLOR_PAL Sub Color Control 0 ~ 15 6
–29R4_AFC AFC Loop Gain Selector (0: High, 1: Medium) 0 / 1 0
–30R8_Y2 DRIVE Y2 Output Gain Control 0 ~ 31 20
–31R9_U2 DRIVE U2 Output Gain Control 0 ~ 31 15
–32R9_PRE OVER Setting of Preshoot to Overshoot ratio of sharpness 0 ~ 3 0
–33R10_V2 DRIVE V2 Output Gain Control 0 ~ 31 15
–34R12_SCP BGF Setting of phase of BGP falling edge in SCP output 0 ~ 3 2
–35R12_SCP BGR Setting of phase of BGP rising edge in SCP output 0 ~ 3 3
–36R0_HUE_PAL Tint Control ( for 50Hz ) 0 ~ 63 35
S 1010 – CXA2101AQ
–0R02_PICTURE Picture Gain Control ( RGB Move Together ) 0 ~ 63 35
–1R05_BRIGHT Main Brightness Control ( RGB Move Together ) 0 ~ 63 45
–2R07_R_DRIVE R Drive Gain Control 0 ~ 63 35
–3A04 R–BLNK R Cut–off Control 0 ~ 255 140
–4R09_B_DRIVE B Drive Gain Control 0 ~ 63 35
–5A03 B–BLNK B Cut–off Control 0 ~ 255 140
–6R13_SUB_BRIGHT Setting for output DC bias of RGBOUT 0 ~ 63 63
–7R17_SUB_CONTRAST Y Contrast Gain Control 0 ~ 15 2
–8R08 G_DRIVE G Drive Gain Control 0 ~ 63 34
–9R03_SYSTEM Signal Frequency Band Setting 0 ~ 3 0
(0: NORMAL 1: FF 2: HD 3: FIX–HD)
–10R15_CR–OFFSET 1 For canceling offset between Cr of IN1 and SELIN systems 0 ~ 15 7
–11R15_CB–OFFSET 1 For canceling offset between Cb of IN1 and SELIN systems 0 ~ 15 7
–12R17_SUB–COL Color Gain Control 0 ~ 15 5
–13R18_SUB_HUE Hue Center Control 0 ~ 15 4
–14R18_CTI–LEVEL Color difference Signal Edge Enhancement Setting 0 ~ 3 3
( 0: OFF, 1: Low, 2 : Medium, 3: High )
–15R23_SUB–SHP Sharpness Center Control 0 ~ 3 1
–16R23_SHP_F0 Sharpness f0 Setting 0 ~ 3 3
–17R23_PRE_OVER Preshoot to Overshoot Ratio Setting 0 ~ 3 1
(0: PRE : OVER 1 : 1.3 , 3: PRE : OVER 3 : 1)
–18R23_LTI_LEVEL Luminance Signal Edge Enhancement Setting 0 ~ 3 0
( 0: OFF, 1: Low, 2 : Medium, 3: High )
–19R24_D_PIC Dynamic picture (Black Expansion) Control 0 ~ 3 0
( 0: OFF, 1: Low : inflection point 30 IRE )
( 2 : Medium : 35 IRE, 3: High : 40 IRE )
–20R24_R–Y/R_NTSC R–Y axis + (R–Y) component setting (0: Max, 15: Min) 0 ~ 15 6
–21R24_R–Y/B_NTSC R–Y axis – (B–Y) component setting (0: Max, 15: Min) 0 ~ 15 5
–22R24_G–Y/R_NTSC G–Y axis – (R–Y) component setting (0: Max, 15: Min) 0 ~ 15 8
–23R24_G–Y/B_NTSC G–Y axis – (B–Y) component setting (0: Max, 15: Min) 0 ~ 15 10
–24R24_R–Y/R_PAL R–Y axis + (R–Y) component setting (0: Max, 15: Min) 0 ~ 15 13
–25R24_R–Y/B_PAL R–Y axis – (B–Y) component setting (0: Max, 15: Min) 0 ~ 15 15
–26R24_G–Y/R_PAL G–Y axis – (R–Y) component setting (0: Max, 15: Min) 0 ~ 15 0
–27R24_G–Y/B_PAL G–Y axis – (B–Y) component setting (0: Max, 15: Min) 0 ~ 15 0
–28R24_R–Y/R_SECAM R–Y axis + (R–Y) component setting (0: Max, 15: Min) 0 ~ 15 13
–29R24_R–Y/B_SECAM R–Y axis – (B–Y) component setting (0: Max, 15: Min) 0 ~ 15 15
–30R24_G–Y/R_SECAM G–Y axis – (R–Y) component setting (0: Max, 15: Min) 0 ~ 15 8
–31R24_G–Y/B_SECAM G–Y axis – (B–Y) component setting (0: Max, 15: Min) 0 ~ 15 4
–32R06_SHARPNESS Sharpness Gain Control 0 ~ 63 32
–33EH Availability of Independent H Input selected by INPUT–SEL 0 / 1 1
–34EV Availability of Independent V Input selected by INPUT–SEL 0 / 1 1
–35IK AKB Loop Operation Status 0 / 1 0
S 1020 – UPD64082
–0R04_DYCOR DY detect coring level (Y movement detect coring) 0 ~ 15 4
–1R04_DYGAIN DY detect gain (Y movement detect gain) 0 ~ 15 15
–2R05_DCCOR DC detect coring level (C movement detect coring) 0 ~ 15 2
–3R05_DCGAIN DC detect gain (C movement detect gain) 0 ~ 15 13
S 1030 – DAC
–0A12 G DETAIL DAC A12 G Pedestal Adj. 0 ~ 100 0
–1R1_COLOR CXA2019AQ Color Adj. (same as item 1000–25 ) 0 ~ 63 20
–2R0_HUE_NTSC CXA2019AQ Tint Adj. (for 60Hz) (same as item 1000–24 ) 0 ~ 63 35
-93-
Group
No.
Data
Range
Initial Value
Function
Item
No.
Item
Electrical Adjustments