Sanyo PLC-XU350A - Page 32

32
Store
To store the adjusted data, select Store and then press the
Point
 button or the SELECT button. Move the highlight to
one of the Modes 1 to 5 in which you want to store, and then
press the SELECT button.
Mode free
To clear the stored data, select Mode free and then press
the Point
 button or the SELECT button. Move the highlight
to the Mode that you want to clear and then press the
SELECT button.
Note:
• Display area (H/V) cannot be selected when 480i, 575i,
480p, 575p, 720p, 1035i,or1080i is selected in the PC
System Menu (p.29).
• When input computer signal to the projector, PC adjust
will become available.
Reset
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then select
Yes. All adjustments will return to their previous figures.
This Mode has stored
parameters.
Values of Total dots, Horizontal,
Vertical, Display area H, and
Display area V.
Vacant
Press SELECT button to
store adjusted data
Press MENU button
to close this dialog
box.
Computer Input
Mode free
Store