Sanyo PLC-XU350A - Page 42

42
Use the Point  buttons to adjust the gamma value to
obtain a better balance of contrast (from 0 to 15).
Gamma
Press the Point  button to decrease the sharpness of the
image; press the Point
 button to increase the sharpness
of the image (from 0 to 15).
Sharpness
An interlaced video signal can be displayed in progressive
mode. Select one of the following options.
Off.......... Disabled.
L1 .......... For an active picture.
L2 .......... For a still picture.
Film........ For watching a film. With this function, the
projector reproduces pictures faithful to the
original film quality.
Progressive
Noise reduction
Noise interference on the screen can be reduced. Select
one of the following options to get smoother images.
Off.......... Disabled.
L1 .......... Lower reduction
L2 .......... Higher reduction
Note:
Noise reduction and Progressive cannot be selected
when 480p, 575p, 720p, 1035i,or1080i is selected
(p.39).
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then select
Yes. All adjustments will return to their previous figures.
Reset
Store
To store the adjusted data, select Store and press the Point
 button or the SELECT button. Use the Point 54 buttons
to select one from Image 1 to 4 and press the SELECT
button.
A confirmation box appears and then select Yes. Stored
data can be called up by selecting an Image (1–4) in the
Image Mode Selection on page 40.
Store Menu
A confirmation box
appears and then
select Yes.
Video Input