Sanyo PLC-XW300

27
Choose either Computer 1(RGB) or Computer 2(RGB) by pressing the COMPUTER 1 or Computer 2 button
on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
3
Computer Input
COMPUTER 1 button
3Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.44).
Computer
1
Remote Control
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
Menu. Use the Point
Ÿź buttons to select Input and
then press the Point
Źor the SELECT button.
Use the Point
Ÿź buttons to select Computer 1.
When Computer 1 is selected,
press the Point
Ź
button
to access the submenu items
. Use the Point Ÿ
ź
buttons to select the RGB input source and then
press the SELECT button.
Computer 1(RGB)
Computer 1(Scart)
Input Source Selection (RGB: Computer 1/Computer 2)
Computer 2 (RGB)
COMPUTER 2 button