Sanyo PLC-XW300

38
Video Input
Video System Selection
1
AV System Menu (Video or S-video)
AV System Menu (Component)
2
If the projector cannot reproduce proper video image,
select a specific broadcast signal format from among PAL,
SECAM, NTSC, NTSC 4.43, PAL-M, and PAL-N.
PAL/SECAM/NTSC/NTSC4.43/PAL-M/PAL-N
The projector automatically detects an incoming video
signal, and adjusts itself to optimize its performance.
If the projector cannot reproduce proper video image, select
a specific component video signal format from among 480i,
575i, 480p, 575p, 720p, 1035i, and 1080i.
Auto
COMPONENT VIDEO SIGNAL FORMAT
Video or S-video
Component
The projector automatically detects an incoming video
system, and adjusts itself to optimize its performance.
When Video System is PAL-M or PAL-N, select the system
manually.
Auto
3Note:
The AV System Menu cannot be selected when selecting
RGB (Scart).
Press the MENU button to display the On-Screen
Menu. Use the Point
Ÿź buttons to select Input and
then press the Point
Ź
or the SELECT button.
Select Video, S-video or Computer 1(Component)
input source. (See pages 36-37)
3
Use the Point Ÿź buttons to select System and then
press the Point
Ź
or the SELECT button. Use the Point
Ÿźbuttons to select the desired system and then
press the SELECT button.
System Video
Component