Computer Input
Computer System Selection
This projector automatically tunes to various types of computers based on VGA, SVGA, XGA, SXGA,
WXGA, or UXGA with its Multi-scan system and Auto PC Adjustment. If Computer is selected as a signal
source, this projector automatically detects the signal format and tunes to project a proper image without
any additional setting. (Signal formats provided in this projector is shown on page 70)
One of the following messages may appear when:
The projector cannot recognize the connected
signal conforming to the provided PC Systems.
The message "Auto" is displayed on the PC
System Menu icon and the Auto PC Adjustment
function works to display proper images. If
the image is not projected properly, a manual
adjustment is required. (p.29-30)
There is no signal input from computer. Check
the connection between your computer and
the projector. (See "Troubleshooting" on pages
64-65.)
Auto
The preset system is manually adjusted in the
PC Adjust Menu. The adjusted data can be
stored in Mode 1 ~ 5. (p.29-30)
PC Systems provided in this projector is
chosen. The projector chooses a proper
system provided in the projector and displays
it.
*Mode 1 and SVGA 1 are examples.
Mode 1
SVGA 1
-----
Press the MENU button to display the On-Screen
Menu. Press the Point buttons to move the red
framed pointer to the PC System Menu icon.
Press the Point ! buttons to move the red arrow
pointer to the system that you want to set, and then
press the SELECT button.
PC system can also be selected manually.
Selecting Computer System Manually
1
2
The Auto PC Adjustment
function operates to adjust
the projector.
PC System Menu
The PC System Menu icon
Selected system is displayed.
Systems on this dialog
box can be selected.
PC System Menu
Custom Mode (1 ~ 5) set in the
PC Adjust Menu. (p.30)
To Next Page
Loading...
Need help?
General
