Sanyo PLC - User Manual

Extron • System 4
xixi
xixi
xi Switcher Series • User’s Manual • P/N 68-402-02 Rev. E
Configuration and ConnectionsSanyo Installation
Page 1
SYSTEM 4
xixi
xixi
xi
PROJECTOR COMMUNICATIONS KIT
ATTENTION!
PLEASE READ THIS DOCUMENT FOR IMPORTANT
INSTALLATION INSTRUCTIONS
THIS KIT HAS BEEN SHIPPED WITH THE FOLLOWING COMPONENTS:
Kit Type: SANYO
Included Communications Adapter(s):
Quantity Part Number Description
1 26-467-01 ADP, UNV, “A”
1 26-489-01 ADP, UNV, “J”
THE TABLE BELOW LISTS THE POSSIBLE CONFIGURATION(S) AND CORRESPONDING
COMMUNICATIONS ADAPTER(S) FOR YOUR PROJECTOR MANUFACTURER’S VARIOUS
MODELS. PLEASE NOTE THAT YOUR SWITCHER HAS BEEN CONFIGURED AS
INDICATED BY THE “✔” IN THE “CONFIG AS” COLUMN. IF YOUR PROJECTOR MODEL
DIFFERS FROM THIS CONFIGURATION, YOU MUST RECONFIGURE YOUR SWITCHER
WITH THE CORRECT SETTINGS.
PLEASE REFER TO THE FOLLOWING PAGES FOR COMPLETE CONFIGURATION AND
SIGNAL CONNECTION INSTRUCTIONS.
THIS SWITCHER HAS BEEN CONFIGURED FOR: SANYO PLC
CONFIG MODEL SW1 SW2 SW3 SW4 SW5 SW6 PROJ COMM
AS 1 2 3 4 CABLE ADAPTER
✔ PLC off on off on 0 0 1 E 0 J15 26-467-01
✔ PLC 8810 off on off on 0 0 1 E 0 J15 26-489-01
PLC XP10 off on off on 0 0 1 E 0 J15 26-489-01
PLC XP30 off on off on 0 1 1 E 0 J15 26-489-01

Sanyo PLC Specifications

General

Brand	Sanyo
Model	PLC
Category	Projector Accessories
Language	English

Summary

Projector Communications Kit Overview

Included Communications Adapters

Lists the quantity, part number, and description of included communication adapters for the kit.

Sanyo PLC Initial Configuration

Details the default configuration settings for Sanyo PLC projectors and the relevant communication adapters.

Connecting System 4 xi to Sanyo PLC Projectors

Verifying System 4 xi Configuration

Steps to verify the System 4xi's configuration for Sanyo PLC using the front panel information menu.

Configuring the Main Controller Board

Instructions for adjusting Main Controller Board switches to match Sanyo PLC projector requirements.

Switcher Switch Settings

Illustrates the specific DIP switch settings (SW1-SW6) required for Sanyo PLC projector compatibility.

System 4 xi Sanyo PLC Physical Connections

Comm Adapter and Extension Cable

Details connecting the Sanyo PLC Comm Adapter and the Projector Communications Extension cable.

RGBS;HV Cable Connection

Explains connecting the RGBS/HV cable (BNC connectors) to the System 4xi and Sanyo PLC projector.

Alternative Connection Method

Describes an alternative connection for PLC projectors without a 9-pin serial port, using DIN adapter.