A
Anna AcostaAug 8, 2025
What to do when the lamp is expiring on Sanyo PLV-WF20?
- MMichael JenningsAug 8, 2025
When the end of lamp life is approaching on your Sanyo Projector, replace the lamp with a new one promptly.
What to do when the lamp is expiring on Sanyo PLV-WF20?
When the end of lamp life is approaching on your Sanyo Projector, replace the lamp with a new one promptly.
Why is the image not bright enough on my Sanyo Projector?
If the image from your Sanyo Projector isn't bright enough, there are several things to check: * Ensure that the 'Contrast' and 'Brightness' settings are properly adjusted. * Verify that the 'Image level' is correctly selected. * Check the Lamp control function. * Consider replacing the lamp with a new one. * Examine the lamp mode in the SETTING section.
How to fix blurry image on Sanyo Projector?
If your Sanyo Projector image is out of focus, try the following: * Adjust the focus of the projector. * Check the Projection Lens and clean it if necessary. * If condensation is present, turn the projector OFF and wait for it to evaporate. * Avoid projecting from an excessive slant angle to the screen, as this can cause keystone distortion and imperfect focus.
Why can't I select some menus on my Sanyo Projector?
If some menus cannot be selected on your Sanyo Projector, it is because each of the Video Input and Computer Input has a limit on selectable menus.
Why doesn't my Sanyo PLV-WF20 Projector save settings after turning off?
If the settings on your Sanyo Projector do not remain after turning off the power, make sure you selected 'Store' after adjusting the settings.
Why isn't power management working on my Sanyo PLV-WF20?
If the power management function on your Sanyo Projector does not work, it may be because the 'Freeze' function is running or the shutter is closed. Power management function cannot work in these cases.
General
