What to do if my Sanyo PLV-Z2000 won't turn on?
If your Sanyo Projector won't turn on, it might have detected an abnormal condition. Try unplugging the AC power cord and plugging it back in to turn on the projector. If the projector turns off again, unplug the AC power cord and contact the dealer or service center for servicing and checkup.
Why won't my Sanyo PLV-Z2000 Projector turn on?
Your Sanyo Projector might not turn on because the projection lamp is cooling down, or the temperature inside the projector is abnormally high. When the projector is cooled down enough and the temperature returns to normal, the POWER indicator emits red light, and the projector can be turned on. Also, the projector may be in Power management mode.
Why Sanyo PLV-Z2000 Projector has no power?
If your Sanyo Projector isn't powering on, there are several potential causes: * The primary power supply circuit might not be working correctly. To troubleshoot, check the Varistor (VA611), the SS3.3V power supply line, and the Power Board. * There could be an issue with the secondary power supply lines. Inspect the S5V, -5V, and 17.5V power supply lines on the Main board. * A problem with the fan control circuits might exist. Examine FN901/902/903/904/905 and the surrounding circuit, as well as connectors K8E/K8F from TH901/TH902. * An abnormality in the power starter signals could be the cause. Verify the POWER_ON_SW signal (Power-on:H) output from pin 9 of IC4801.
Highlights primary features including zoom lens, lens shift, image modes, connectivity, and power management.
Covers critical safety warnings, electrical precautions, and handling advice for safe operation.
Details on safe operation, electrical hazards, servicing safety, and installation precautions.
Provides detailed technical data including dimensions, weight, and operating specifications.
Details all buttons and functions of the remote control for projector operation.
Guidance on projector positioning, screen size, and using adjustable feet.
Steps for connecting Component, S-Video, and standard Video sources.
Instructions for safely connecting the projector to AC power outlets.
Step-by-step guide for projector startup and shutdown procedures.
How to access and operate the projector's menu system for settings.
Methods for choosing input signals via remote or menu system.
Choosing optimal picture presets for different viewing conditions.
Guide for replacing the projection lamp and resetting the counter.
Solutions for problems like no power, no image, focus, and noise.
General| Vertical scan range | 50 - 100 Hz |
|---|---|
| Horizontal scan range | 15 - 80 kHz |
| Projection technology | LCD |
| Contrast ratio (typical) | - |
| Focus | Manual |
| Digital zoom | 2 x |
| Focal length range | 22.6 - 45.3 mm |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 400 x 346 x 146 mm |
| Power requirements | 100 - 240V |
| Connectivity technology | Wired |
| Lamp type | UHP |
| Lamp power | 165 W |
| Light source type | Lamp |
| Full HD | Yes |
| Serial interface type | RS-232 |
| Component video (YPbPr/YCbCr) in | 2 |
| Noise level | 26 dB |
| Power consumption (typical) | 240 W |
Weight and Dimensions| Weight | 7300 g |
|---|
To Next Page
