Sanyo PLV-Z2000 User Manual

9
D COMPUTER
Connect the computer output signal, or RGB Scart 21-pin
video output to this connector (p.16).
Rear Terminal
D J
G
8
L
VIDEO
Connect the composite video output signal from video
equipment to this jack (p.15).
8 COMPONENT 1 or COMPONENT 2
Connect the component video output signal to these jacks
(p.15).
J S-VIDEO
Connect the S-Video output signal from video equipment
to this jack (p.15).
E SERVICE PORT
This jack is used to service the projector.
E
L
G HDMI 1/HDMI 2*
Connect the HDMI output signal from video equipment
to these terminals (p.16).
*Note on the HDMI connector:
Use the HDMI connector less than the size shown below.
Otherwise you cannot connect use HDMI 1 and HDMI 2
terminals at the same time.
0.94" (24 mm)
0.59" (15 mm)
WIDTH THICKNESS
Maximum dimensions of the HDMI connectors
Part Names and Functions

Sanyo PLV-Z2000 Specifications

General

Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Focus	Manual
Digital zoom	2 x
Focal length range	22.6 - 45.3 mm
RS-232 ports	1
Dimensions (WxDxH)	400 x 346 x 146 mm
Power requirements	100 - 240V
Connectivity technology	Wired
Lamp type	UHP
Lamp power	165 W
Light source type	Lamp
Full HD	Yes
Serial interface type	RS-232
Component video (YPbPr/YCbCr) in	2
Noise level	26 dB
Power consumption (typical)	240 W

Weight and Dimensions

Weight	7300 g