12
To ensure safe operation, please observe the following precautions:
OUse two (2) AA or LR6 type alkaline batteries.
OAlways replace batteries in sets.
ODo not use a new battery with a used battery.
OAvoid contact with water or liquid.
ODo not expose the remote control to moisture or heat.
ODo not drop the remote control.
OIf the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
ORisk of explosion if battery is replaced by an incorrect type.
ODispose of used batteries according to the instructions.
Point the remote control toward the projector (Infrared Remote Receiver) when pressing any buttons. Maximum operating
range for the remote control is about 16.4’ (5 m) and 60 degrees in front of the projector.
16.4’
(5 m)
30°
Remote Control Operating Range
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the compartment lid.
12 3
* When the batteries of the remote control are replaced, the remote
control code automatically returns to the initial code (Code 1) (p.41).
Remote control
Part Names and Functions
Two AA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
Pull up the lid
and open it.
Remote Control Battery Installation
30°
To Next Page
Loading...
