Sanyo SAP–KR184GJH - Page 34

■
Heating
●
Room temperature control is obtained by cycling the compressor ON and OFF under control of the room
temperature sensor in the remote control unit.
●
The room temperature (and other information) is transmitted every 5 minutes by the remote control unit to the
controller in the indoor unit.
●
Once the compressor starts, it keeps running for 5 minutes.
●
Once the compressor stops, it will not start running again for 5 minutes.
●
Thermo ON : When room temperature decreases below –1°C below the set temperature T˚C.
Compressor
➞
ON
●
Thermo. OFF : When the room temperature rises 1°C above the set temperature T°C.
Compressor
➞
OFF
● Whenever the compressor is running, the indoor unit always generates negative ions. (ION lamp lights up.).
● The temperature described in this page and previous page gives you an example with remote control operation.
In case of a body sensor operation, operation temperature differ somewhat.
NOTE
ON OFF ONCompressor OFF
OFF
ONOutdoor fan
4–way valve
OFF
ON
Thermo.
OFF
Thermo.
ON
Thermo.
OFF
T+1 °C
T °C
T–1 °C
Set temp.
Room temp.
5 minutes 5 minutes 5 minutes 5 minutes 5 minutes 5 minutes
Signal from remote control unit
ON
34