18
5. ADJUSTING THE AIRFLOW DIRECTION CORRECTLY
6. TROUBLESHOOTING
1. Horizontal
The horizontal airflow can be adjusted by moving the louver
with your hand to the left or right.
When the humidity is high, the vertical vanes should be in
the front position during the cooling or dehumidifying
operation. If the vertical vanes are positioned all of the
way to the right or left, condensation may begin to form
around the air vent and drip down.
2. Vertical
The vertical airflow can be adjusted by moving the flap with
the remote control unit.
Use the SWING button to set either the auto sweep or set to
the recommended position.
• Use the SWING button on the remote control unit to
adjust the position of the flap. If you move the flap by
hand, the flap position according to the remote control
and the actual flap position may no longer match. If this
should happen, shut off the unit, wait for the flap to
close, and then turn on the unit again; the flap position
will now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
Do not attempt to repair the air conditioner by yourself, as this can cause an electric shock or fire.
Please check the following items before asking for repairs, as this can save time and money.
Problem Solution
Does not operate immediately when the air
conditioner is restarted.
When the air conditioner is restarted immediately
after being turned off, the overload protection switch
will delay starting for three minutes.
F
A
N
O
P
E
R
S
WING
A
M
C
O
N
O
N
/O
FF
F
A
N
T
E
M
P
-
T
E
M
P
+
M
O
D
E
TI
M
E
-
C
A
N
C
E
L
T
I
M
E
+
S
W
I
N
G
S
L
E
E
P
T
-
O
N
T
-
O
F
F
C
L
O
C
K
CAUTION
CAUTION
CAUTION
Waiting
OI-180-18-EG
01_SAP-KRV9AEH_EN.fm Page 18 Tuesday, June 8, 2010 3:40 PM
To Next Page
Loading...
Need help?
General
