Sanyo SCP-8400 - Page 206

190 Section 2K: Using Sprint PCS Ready Link
Making a Sprint PCS Ready Link Call by Entering
a Number
To place a Sprint PCS Ready Link call by entering a number:
1. From standby mode, enter the Sprint PCS Ready Link
number you want to dial.
2. Press to place the Sprint PCS Ready Link call.
Continue holding to take the floor and speak.

The contact’s name appears on the display if there is
a matched number in your Sprint PCS Ready Link List.
3. Continue with the Sprint PCS Ready Link call, pressing
and holding to speak and releasing it to allow
others to reply.
4. When the call is finished, press .
– or –
1. Press .
2. Press Go to (left softkey), highlight Enter R-Link# and
press .
3. Enter the Sprint PCS Ready Link number you want to dial.
4. Follow steps 2–4 above.
Note:Sprint PCS Ready Link numbers must contain 10 digits (area code +
phone number) or 11 digits (1 + area code + phone number). Your Sprint PCS
Ready Link number is the same as your phone number.