ALARM RECORDING
Alarm Search
To go to the beginning of a desired alarm recording.
1
Press the STANDBY/ON button.
2
Press the SEARCH button during stop mode.
ø “AL SEARCH 01” appears on screen.
3 Press the REC/PLAY SPEED l (or j) button to set
the desired alarm number (01 to 99), then turn the
SHUTTLE ring clockwise (or counterclockwise).
ø The desired alarm is searched for and a still
image of the beginning of the alarm recording
appears on-screen.
NOTE:
œ The alarm number is relative to the actual tape
position. (Please refer to the illustration below.)
4
Press the PLAY button.
ø Playback starts.
NOTES:
œ If the end of the tape is reached during a search, the
tape will rewind and stop. If the beginning of the tape
is reached, it will stop.
œ This function does not operate when a warning
display appears on the digital display.
Alarm Scan
To look for an alarm recording by viewing the first 5
seconds of each alarm recording.
1
Press the STANDBY/ON button.
2
Press the SEARCH button twice during stop mode.
ø “AL SCAN” will be displayed on screen.
3
Turn the SHUTTLE ring clockwise (or
counterclockwise).
ø The unit will advance (or rewind) the tape at
high speed and playback the first 5 seconds of
every alarm recording.
ø To cancel the alarm scan mode, press the
STOP button.
4
While the desired recording is being played back,
press the PLAY button.
ø Playback starts and alarm scan mode is
canceled.
NOTES:
œ If the end of the tape is reached during a scan, the
tape will rewind and stop. If the beginning of the tape
is reached, it will stop.
œ This function does not operate when a warning
display appears on the digital display.
Playback
112
Rewind direction
Fast-forward direction
Actual position
Alarm number 2
Alarm trigger input point
RQ4Q/EX (TLS-1960P GB) Wed. May, 08/2002
26
English
To Next Page
Loading...
