TURNING THE CAMERA ON AND OFF
In order to preserve battery pack power, the power save (sleep) function will
automatically turn off the camera after about 1 minute of no use during
shooting, or about 5 minutes of no use during playback (factory-preset
setting).
• When the power save mode is active, you can restore the power by any of
the following methods:
Move the REC/PLAY switch.
Press the ON/OFF button.
Press the [ O ] or [ =4 ] button.
Press the SET or MENU button.
Push the zoom switch.
Move the SIMPLE/NORMAL switch.
Press the PHOTO VIEW button.
• When the MENU button is used to turn on the camera, the screen to
set the operation sounds appears.
• After the power save mode has been active for about 1 hour, the camera
will switch to the standby mode. In this case, you can restore the power by
pressing the ON/OFF button, or by closing and then opening the monitor
unit.
• When the AC adaptor is connected, the power save mode will become
active about 5 minutes after the camera is turned on (factory-preset
setting).
• The user can specify the time elapsed before the power save mode is
activated (page 140).
• When the camera is connected to a computer or printer, the power save
mode becomes active after about 12 hours.
41 English
To Next Page
Loading...
