Sartorius BA 610 - Balance Assembly and Startup; Installing Weighing Chamber Components; Initial Setup for Specific Models

13
Installing Components in the Weighing Chamber
Install the components in the following order:
- protective bushing
(5)
- protective ring
(4)
- pan support
(3)
- compensating ring
(2)
- weighing pan
(1)
Starting Up the BA 310 S and BA 310 P
- Place the draft shield base plate
(22)
on the balance and turn it
clockwise until it locks in place
Install the following parts on the balance in this order:
- pan support
(3)
- weighing pan
(1)
- glass cylinder of the round draft shield
(21)
- draft shield lid
(20)
Starting Up the BA 110
- Place the draft shield base plate
(22)
on the balance and turn it
clockwise until it locks in place
Install the following parts on the balance in this order:
- - protective ring
(4)
- - pan support
(3)
- - compensating ring
(2)
- - weighing pan
(1)
- - glass cylinder of the round draft shield
(21)
- - draft shield lid
(20)
Starting Up the BA 210
Place the weighing pan
(1)
on the balance