The current code setting in the balance operating menu
is identified by a small, superscript “
o
” after the last
number. When you access the operating menu, the
previously set code will be displayed after you have
selected the right-hand number, which means the entire
menu code setting will be displayed. This makes it
easy for you to check the previously set menu codes.
If you would like to change several menu code
settings, you do not have to press a t key after each
change to exit the balance operating menu.
You can also confirm individual settings.
Important Note Concerning Standard Balances:
Please do not forget to relock the balance operating
menu to avoid inadvertent changes to the settings.
The symbol “–” indicates that the menu is locked.
Exiting the Menu without Storing Code Changes
Changes to the code settings are not stored if you turn
off the balance by pressing e while selecting the
code numbers or before pressing t to save a setting.
Undoing All Menu Code Changes – Reset Function
The reset function lets you undo all menu code
changes, which means that you will obtain the original
factory-set menu codes identified by an “*.” To use
this function, select code 9 – – 1
o
. See the previous
page for information on confirming and storing
a menu code setting.
Reset function Code
On 9 – – 1
Off 9 – – 2
* including the Signatories of the Agreement on the
European Economic Area
Important Note Concerning Verified Balances
Approved for Use as Legal Measuring Instruments
in the EU*:
The balance operating menu on verified balances
cannot be locked with the menu access switch
(“–” not displayed).
30
To Next Page
Loading...
Need help?
General