Sartorius Cubis MCA225S Series User Manual

Operating Instructions Cubis
®
MCA 55
Getting Started
6.2 Connecting the Power Supply
Procedure
t
WARNING Severe injuries caused by using a defective power supply
cable! Check the power supply cable for damage, e.g., cracks
intheinsulation.
t If required: Contact Sartorius Service.
t Check whether the country-specific power plug matches the power
connections at the installation site.
t If required: Contact Sartorius Service.
t NOTICE Damage to the device due to excessive input voltage!
Checkwhether the voltage specifications on the AC adapter match
those of the power supply at the installation site.
t If the input voltage is too high: Do not connect the device
tothepower supply.
t Contact Sartorius Service.
t Connect the mains plug of the power supply cable to the wall outlet
atthe installation site.
y The [Booting device...] display appears in the operating display.
y The [Starting system...] display appears in the operating display.
y The [Starting application...] display appears in the operating display.
y The [Loading] display appears in the operating display.
y The device performs an initial tare function.
6.3 Attaching the Protective Caps
If connections of the device are not being used during operation:
Theconnections must be sealed with the protective caps supplied.
Procedure
t Check whether all unused connections have been sealed
withaprotective cap.
t Place the protective caps (1) for the electrical connections
ontheunusedconnections.
1

Sartorius Cubis MCA225S Series Specifications

General

Brand	Sartorius
Model	Cubis MCA225S Series
Category	Laboratory Equipment
Language	English