You can use the Combics 3 to collect
weight values from two weighing
platforms, calculate and display weight
values through application programs,
and assign IDs to the samples weighed.
Configure the indicator Setup menu
for the desired application program first
(printer settings, etc.). Then you can
begin weighing.
Data Input
Keypad Input
Labeled Keys
Some keys have a second function,
activated by pressing and holding the
key for at least 2 seconds. Whether
a function is available depends on the
indicator operating state and Setup
menu settings.
e On/off
(in standby mode,
OFF is displayed.)
n When two platforms are
connected, this key toggles the
display between the two readouts.
( – Zero the scale
– Cancel calibration/adjustment
) – Press briefly:
Tare the weighing platform.
– Press and hold (> 2 sec.):
Activate calibration/adjustment
k Toggle between 1st and 2nd
weight unit, or gross and net values,
or normal and 10-fold higher
resolution, depending on operating
menu settings.
p – Press briefly: Print
– Press and hold: Print GMP footer
D Press and hold: Toggle to info mode
M – Access to Setup program
– Exit the Setup program
c – Press briefly: Quit application
program or delete input character
– Press and hold: Delete entire
input string
0, 1, 2 … 9, .
Enter numbers, letters and other
characters
a Toggle between numeric and
alphabetic input
10
Operating Elements: Combics 3
Operating Design
To Next Page
Loading...
Need help?
General
