Safety Information
§ To prevent damage to the equipment,
read these operating instructions
carefully before using your Combics.
! Do not use this equipment in hazardous
areas/locations.
! The indicator may be opened only by
trained service technicians.
! Disconnect the indicator from power
before connecting or disconnecting
peripheral devices.
! If you operate the equipment under
ambient conditions subject to higher
safety standards, you must comply
with the applicable installation
regulations.
Installation
– Proceed with extreme caution when
using pre-wired RS-232 connecting
cables, as the pin assignments may
not be compatible with Sartorius
equipment. Check all pin assignments
against the cabling diagrams and
disconnect any lines that are not
assigned. The operator shall be solely
responsible for any damage or injuries
that occur when using cables not
supplied by Sartorius.
! Use only standard cables that have
protective grounding conductors.
The protective conductor must not be
disconnected for any reason.
! If there is visible damage to the
equipment or power cord, unplug the
equipment and make sure it cannot
be used for the time being.
– Connect only Sartorius accessories
and options, as these are optimally
designed for use with your Combics.
The operator shall be solely responsible
for installation and testing of any modi-
fications to Sartorius equipment,
including connection of cables or
equipment not supplied by Sartorius.
Contact Sartorius for detailed operating
specifications in accordance with the
Standards for immunity to interference.
$ If you have any problems with your
Combics, contact your local Sartorius
office, dealer or service center.
IP Protection
– CISL models are rated to IP44
(with Option L1: IP65); CIS models are
rated to IP67.
– The IP65/IP67 protection rating
is ensured only if the rubber gasket
is installed and all connections are
fastened securely (including the caps
on unused sockets). Weighing plat-
forms must be installed and tested
by a certified technician.
– If you install an interface port after
setting up your indicator, keep the
protective cap in a safe place for future
use. The cap protects the interface con-
nector from vapors, moisture and dust
or dirt.
Using the Equipment in
Legal Metrology
– When the indicator is connected to a
weighing platform and this equipment
is to be verified, make sure to observe
the applicable regulations regarding
verification. Please read and observe
the “Guide to Verification” on the
enclosed CD. When connecting
a Sartorius weighing platform, observe
the permitted weighing range as listed
in the Declaration of Conformity.
– If any of the verification seals are dam-
aged, make sure to observe the regula-
tions and standards applicable
in your country in such cases.
In some countries, the equipment
must be re-verified.
4
Warnings and Safety Precautions
To Next Page
Loading...
Need help?
General
