37
Operating the Balance
Preparation
To calculate a value in percent, the
reference percentage must be
known. This value can be entered
into the weighing-in-percent program
in one of three ways:
– The last reference percentage
entered is loaded and displayed
when you turn on the balance.
Place the corresponding weight
on the balance and initialize the
weighing-in-percent program;
– With automatic initialization
switched on, the balance goes
into the “weighing in percent”
mode when you turn it on and
loads the last reference percent-
age entered as well as the
corresponding reference weight;
– Enter the reference weight
using the numeric keys and store
it (W100% soft key).
● Turn on the balance:
Press e
> All display segments light up
briefly
● Select the Weighing-in-Percent
application in the Setup menu:
Press M
● Select menu:
Press the menu soft key (w)
● Set parameter 2 1 5:
See “Configuring the Balance”
● Exit the Setup menu:
Press M
Setting Parameters for the Weighing-
in-Percent Application
k Access the Setup menu:
Select Menu
● Set parameters for:
– Storage accuracy:
3 5 Count/pct. param.
– Decimal places displayed:
3 6 decimals f. calc.
– Automatic initialization:
3 10 auto-start app.
– Automatic output of parameters
to interface port:
7 1 Print app. param.
See “Configuring the Balance”
● Exit the Setup menu:
Press M
Additional Functions
In addition to functions for:
– alphanumeric input,
– taring
(not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration
(not during alphanumeric input),
– setup,
– turning off the balance.
Calibration/Adjustment
● Press q
> See “Calibration/Adjustment”
for further instructions
Setup (setting parameters)
● Press M
> See “Configuring the Balance”
for further instructions
Turning Off the Balance
● Press e
> The balance shuts off
> The display goes blank
To Next Page
Loading...