43
Operating the Balance
Preparation
● Turn on the balance:
Press e
> All display segments light up
briefly
● Select the animal weighing
application in the Setup menu:
Press M
● Select menu:
Press the menu soft key (w)
● Set parameter 2 1 7:
See “Configuring the Balance”
● Exit the Setup menu:
Press M
Setting Parameters for the
Animal Weighing Application
k Access the Setup menu:
Select Menu
● Set parameters for:
– Start range:
3 7 Animal activity
– Start animal weighing
3 8 Start animal wgh.
– Printout of results and
calculated results:
3 9 Print animal wts.
– Automatic output to
interface port:
7 1 Print app. param.
See “Configuring the Balance”
● Exit the Setup menu:
Press M
Additional Functions
In addition to functions for:
– alphanumeric input
(not when automatic start is
configured or after animal
weighing has been started),
– taring
(not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration (not during alpha-
numeric input or after animal
weighing has been started),
– setup (not after animal weighing
has been started),
– turning off the balance.
Calibration/Adjustment
● Press q
> See “Calibration/Adjustment”
for further instructions
Setup (setting parameters)
● Press M
> See “Configuring the Balance”
for further instructions
Turning Off the Balance
● Press e
> The balance shuts off
> The display goes blank
Practical Example
See next page
To Next Page
Loading...