Sartorius LP Models - Recalculation Application Setup; Preparation and Parameter Configuration; Recalculation Parameter Settings

52
Factory Settings
Print application parameters
(automatic output of application
parameters): off (7 1 1)
Line format: for other apps/GLP
(7 2 2)
Preparation
● Turn on the balance: Press e
> All display segments light up
● Select the Recalculation applica-
tion in the Setup menu: Press M
● Select menu:
Press the menu soft key (w)
● Set parameter 2 1 9:
see “Configuring the Scale”
● Exit the Setup menu: Press M
Setting Parameters for the
Recalculation Application
$ Access the Setup menu:
Select MENU
● Set parameters for:
– Automatic printout:
7 1 Print app. para.
– Line format:
7 2 Line format
see “Configuring the Balance”
● Exit the Setup menu: Press M
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric
input), and
– printing,
you can also access the following
functions from this application:
– calibration
(not during alphanumeric input)
– setup
– turning off the balance.
Calibration/Adjustment
● Press q
> See “Calibration/Adjustment”
for further instructions
Setup (setting parameters)
● Press M
> See “Configuring the Balance”
for further instructions
Turning Off the Balance
● Press e
> The balance shuts off
> The display goes blank